ESP32 – Beyondlogic

ESP32-WROOM-32 Breakout Board

December 16, 2020 Craig Peacock 2

Featured here is a breakout board for the Espressif Systems ESP32-WROOM modules incorporating a MCU with WiFi and Bluetooth connectivity. The board is designed to be minimalist and targeted towards battery operated devices. As such, no voltage regulator is included. For those not already familiar with the ESP32, this SoC offers the following features: Xtensa dual-core 32-bit LX6 microprocessor running up to 240MHz. 448KB rom for bootloader and core functions. 520KB SRAM (plus 16KB SRAM contained in RTC). 802.11b/g/n WiFi up to 150 Mbps. Bluetooth V4.2 BR/EDR and Bluetooth LE. 3.0 to 3.6V operation. A datasheet for the latest ESP32-WROOM-32E …

Espressif esp-idf & Eclipse IDE: Debugging with JTAG and OpenOCD

November 28, 2020 Craig Peacock 3

Developing ESP32 code by iteratively downloading code to your target via esptool can become laborious for anything but the smallest of projects. In addition to the UART Bootloader, the ESP32 can also be programmed and debugged via the JTAG interface. Debugging allows single stepping through your code, adding breakpoints and examining the contents of registers. Besides the rich debugging, programming over JTAG can also speed up development as the JTAG interface can be as fast as 20MHz as opposed to the serial download at a typical 460,800 bps. Setup This tutorial assumes you have Eclipse and the esp-idf set-up on …

Getting Started with the Espressif esp-idf & Eclipse IDE

October 24, 2020 Craig Peacock 4

The Espressif IoT Development Framework (esp-idf) is the official development platform for the ESP32 and ESP32-S series of SoCs from Fabless Semiconductor designer Espressif Systems. Espresif have developed the IDF eclipse plugin to make the setup and integration of the esp-idf with the eclipse IDE simple and relatively painless. Installation consists of four main steps: Install the Eclipse IDE Install the Espressif IDF Plugin for Eclipse Download and configure the esp-idf Install the esp-idf build tools Once installed, we run through the basics: Importing an IDF project Building Flashing SDK Config This tutorial will work you through setting up Eclipse …