Beyondlogic




  • Home
  • LoRaWAN
  • Power
  • Embedded Linux
  • CANbus
  • Electronics Hardware
  • Wiki
  • USB In a Nutshell
Sneak Peek
HomeLT8490

LT8490

Electronics Hardware

LT8490 MPPT Buck-Boost Multi-Chemistry Battery Charger

September 4, 2019 Craig Peacock 2

Most PV solar regulators are buck (step down) regulators and require the PV panel voltage to be above the battery voltage. This design uses a buck-boost topology and allows the PV solar voltage to be above, below or equal to the battery voltage. For example, you could charge a 48V …

Advertisement




External sites

Fresh new content in development (or let’s be honest, never finished) can be found at:

      • CircuitMaker
      • Github
      • Wiki 

Recent Comments

  • Craig Peacock on LoRaWAN: Upgrading to Basic Station and The Things Network V3 Stack
  • Ernst Schulz on LoRaWAN: Upgrading to Basic Station and The Things Network V3 Stack
  • Nick on Review: Li-ion LiPo LiFePO4 Lithium Battery Active Equalizer Balancer Energy Transfer Board
  • Craig Peacock on ESP32-WROOM-32 Breakout Board
  • Robert Juncosa on ESP32-WROOM-32 Breakout Board
  • Markus Frömmel on LT8390 Synchronous Buck-Boost DC-DC Converter
  • Richard Jesch on Review: Li-ion LiPo LiFePO4 Lithium Battery Active Equalizer Balancer Energy Transfer Board
  • Rainer Hartz on Getting Started with the Espressif esp-idf & Eclipse IDE
  • Alberto on An Introduction to chardev GPIO and Libgpiod on the Raspberry PI
  • Rod on Review: Li-ion LiPo LiFePO4 Lithium Battery Active Equalizer Balancer Energy Transfer Board

Advertisement




Copyright 2020 • Craig Peacock • Adelaide • Australia