Beyondlogic




  • Home
  • LoRaWAN
  • Power
  • Embedded Linux
  • CANbus
  • Electronics Hardware
  • Wiki
  • USB In a Nutshell
Sneak Peek
HomeATZ9712

ATZ9712

Software

ATZ97 / M97 Series Programmable DC Load Modbus Interface Software

May 7, 2019 Craig Peacock 0

The Atten ATZ97 / Maynuo M97 Series programmable DC loads has a RS-232 port that can be used for instrument control and acquisition. Rather than using more conventional text based SCPI (Standard Commands for Programmable Instruments) commands, these instruments use Modbus, a protocol designed for PLCs (Programmable Logic Controllers). The …

Advertisement




External sites

Fresh new content in development (or let’s be honest, never finished) can be found at:

      • CircuitMaker
      • Github
      • Wiki 

Recent Comments

  • Craig Peacock on LoRaWAN: Upgrading to Basic Station and The Things Network V3 Stack
  • Ernst Schulz on LoRaWAN: Upgrading to Basic Station and The Things Network V3 Stack
  • Nick on Review: Li-ion LiPo LiFePO4 Lithium Battery Active Equalizer Balancer Energy Transfer Board
  • Craig Peacock on ESP32-WROOM-32 Breakout Board
  • Robert Juncosa on ESP32-WROOM-32 Breakout Board
  • Markus Frömmel on LT8390 Synchronous Buck-Boost DC-DC Converter
  • Richard Jesch on Review: Li-ion LiPo LiFePO4 Lithium Battery Active Equalizer Balancer Energy Transfer Board
  • Rainer Hartz on Getting Started with the Espressif esp-idf & Eclipse IDE
  • Alberto on An Introduction to chardev GPIO and Libgpiod on the Raspberry PI
  • Rod on Review: Li-ion LiPo LiFePO4 Lithium Battery Active Equalizer Balancer Energy Transfer Board

Advertisement




Copyright 2020 • Craig Peacock • Adelaide • Australia